Start your Measurement by clicking Start logging

A Blue Light will flash from the Base Station logger to indicate that it is in logging mode.

You may now disconnect the Base Station from your PC. It is recommended that you keep your Base Station charging during measurements, as the Autonomous Battery Life is approximately 48 hours; Below the minimum required 72 hours for an ISO 9869 conforming measurement.

NOTE: If you wish to check that measurements are being taken, then click Real-time measurement on the Home Page to see the incoming signals. Readings may not show up straight away due to frequency of signals being sent from nodes. The base station has to be plugged into the computer.

<aside> 💡 Base station placement recommendations

</aside>

• The ideal placement for the Base Station is in a direct line-of-sight with the measurement nodes.
• greenteg observed an indoor range of 50m with the signal travelling through concrete walls, and an outdoor signal range of over 200m.
  • This Range can worsen with the amount of obstacles between the measurement nodes and the Base Station. Range is particularly worsened by Thick Walls, and those made from Concrete.
• If Measurements are being taken on Different Floors/Stories, avoid placing the Base Station directly above/below Nodes.